So if we think about where these parts will work for us, what can we do,Īs plc goes to a fault in controller fault handler section, we can catch the error code.
Power-Up Handler, on the other hand, has a similar structure as the controller fault handler, it only works when the PLC is first energized. On the Controller Fault Handler tab, the programs that will run when the PLC program fails are collected under this folder. Tags are the addresses we will use in plc.
You must make the slot and version settings correctly, otherwise an error will occur while loading the program.įor this reason, I pass the creation of a project.īriefly, if we take a look at the tabs under the controls.Ĭontroller tags: We can see all the tags we created here. You can find the project settings in our previous article.
We made Studio 5000 settings in our previous article. When we open Studio 5000 program, we will see the window as below by default.
0 kommentar(er)
